- 39 -
5. Manual Operation tab
(1) Manual operation
The manual operation of the magnet gripper can be checked.
By tapping the HOLD or RELEASE button, it is possible to perform a holding or releasing action of the
gripper.
(2) Monitor sensor signal
It is possible to confirm whether the Hold position or Release position auto switch reacts.
5-4. Air supply
Warning
1. Type of fluids
Please consult with SMC when using the product in applications other than compressed air.
2. When there is a large amount of drainage
Compressed air containing a large amount of drainage can cause the malfunction of pneumatic equipment.
An air dryer or water separator should be installed upstream from filters.
3. Drain flushing
If condensation in the drain bowl is not emptied on a regular basis, the bowl will overflow and allow the
condensation to enter the compressed air lines. This causes the malfunction of pneumatic equipment. If the
drain bowl is difficult to check and remove, the installation of a drain bowl with an auto drain option is
recommended. For compressed air quality, refer to the SMC Best Pneumatics No. 6 catalog.
4. Use clean air.
Do not use compressed air that contains chemicals, synthetic oils that include organic solvents, salt,
corrosive gases, etc., as it can cause damage or malfunction.
Caution
1. When extremely dry air is used as the fluid, degradation of the lubrication properties inside the
equipment may occur, resulting in reduced reliability (or reduced service life) of the equipment.
Please consult with SMC.
2. Install an air filter.
Install an air filter upstream near the valve. Select an air filter
with a filtration size of 5 μm or smaller.
3. Take measures to ensure air quality, such as by installing an aftercooler, air dryer, or water
separator.
Compressed air that contains a large amount of drainage can cause the malfunction of pneumatic
equipment, such as magnet grippers. Therefore, take appropriate measures to ensure air quality, such as
by providing an aftercooler, air dryer, or water separator.
Summary of Contents for MHM-25D-X7400A-DTP-N
