Regulator
clip
Switch body
Concave groove
Pin
Lever
Cover
Precautions on Regulator
Handling
Caution
One-touch fitting replacing procedure
One-touch fitting is a type of cassette. So, it can be replaced
easily.
One-touch fitting is secured with the clip from the bottom of the
regulator body to prevent disconnection. After the regulator has
been removed, take out the clip with a flat blade screwdriver and
replace the One-touch fitting with a new one.
To mount a new One-touch fitting, insert it until it is in contact
with the inner part, and then insert the clip to the specified
position again.
Connector mounting procedure
Pinch the lever and connector body by fingers and insert the
lever straight into the pin. Push the lever claw into the concave
groove of the switch body to lock it.
Connector removing procedure
Push down the lever by your thumb to disengage the claw from
the concave groove and pull out the lever straight to remove it.
Series
LLB1
Specific Product Precautions 3
Be sure to read before handling.
Refer to front matter 43 for Safety Instructions.
348