![background image](http://html1.mh-extra.com/html/smc-networks/lecsn-t-series/lecsn-t-series_operation-manual_1299644038.webp)
-37-
7.2.2 EtherNet/IP Communication setting
The following describes the setup and startup of EtherNet/IP communication.
For details, refer to "LECSN-T Operation Manual, Section 19.1
”.
(1) Connection with upper side
The device type of LECSN-T connected to the EtherNet/IP network card (LEC-S-N9) corresponds to
the generic device type, and there is no EDS file.
Please configure the generic device type for the upper side. For details, please refer to the manual of
the host device to be used.
Note. When setting up the device as a generic device
Set the I/O communication format (input) Output data to Instance 150 and map size to 64 bytes.
Set the I/O communication format (output) Input data to Instance 100 and the map size to 64 bytes.
For details, refer to "LECSN-T Operation Manual, Section 19.3.2
”.
(2) IP address setting
Set an IP address using the
“AnybusIPconfig tool” offered by HMS Industrial Networks and the axis
selection rotary switch (SW2/SW3) on the display of the driver. Change the IP address with the axis
selection rotary switch (SW2/SW3) before powering on the driver. The IP address you set can be
checked with the "AnybusIPconfig tool
” or system configuration window of MR Configurator 2
TM
.
"AnybusIPconfig tool” can be downloaded from the following link (SMC website).
https://www.smcworld.com/assets/manual/other/files/IPConfigTool.zip
You can set an IP address as follows.
Axis selection rotary
switch (SW2/SW3)
IP address setting value
00h
An IP address set by the AnybusIPconfig tool is used.
01h to FEh
Although an IP address set by the AnybusIPconfig tool is used, the
fourth octet value is replaced with a value set with the axis selection
rotary switch (SW2/SW3). The DHCP function is disabled.
Set a hexadecimal value with the axis selection rotary switch
(SW2/SW3). The hexadecimal value is converted into a decimal value
and set as the fourth octet of the IP address.
FFh
The DHCP function is enabled.