QuickServer Start-Up Guide
Page 33 of 46
Appendix A.3. M-Bus Connection R2 Port
The M-Bus driver allows the FieldServer to transfer data to and from devices using M-Bus protocol. The
Fieldbus connection is included with the FieldServer. The M-Bus QuickServer Gateway is configurable to
act as both a Master and a Slave M-Bus device.
The M-Bus Connector consist of a + and
– terminal. Most M-Bus Devices are not polarity sensitive,
although the polarity of the M-Bus Connector is indicated on the device diagram, should it be a
requirement. The M-Bus devices communicating with the FieldServer must be configured according to the
man
ufacturer’s instructions (e.g. primary address and readout data).
The following baud rates are supported on the R2 Port:
300, 600, 1200, 2400, 4800, 9600, 19200, 38400
Appendix A.4. Enhanced Network Security
For enhanced network security, one can disable RuiNet access to a FS-GUI capable FieldServer by use
of the RUI_Enable FieldServer parameter. Adding the following to the configuration file will disable RuiNet
Access.
FieldServer
Title
, RUI_Enable
FieldServer Name , Disabled // Enabled -- is the default if not specified
NOTE:
In order to take a FieldServer Diagnostics log, RuiNet access has to be enabled again.
Figure 25: M-Bus R2 Port