![background image](http://html.mh-extra.com/html/smc-networks/ez-connect/ez-connect_user-manual_1300010019.webp)
9
T
ROUBLESHOOTING
Symptom
You cannot connect to the network
.
Probable Causes
• You did not install the software driver and USB/Ethernet
Converter as indicated in this manual.
Possible Solutions
•
Uninstall the driver from your operating system, power off and
disconnect any devices attached to the converter, and
disconnect it from the USB port.
•
Reinstall the converter according to the installation instructions
in this manual.
Symptom
The Link/Act LED does not light
Probable Causes
There is a connection or cabling problem
Possible Solutions
•
Check that the network hub or switch is powered on.
•
Be sure the network cable is properly connected to both
devices.
•
Verify that Category 5 cable is used for 100 Mbps connections
and that the length of the cable does not exceed 100m (328 ft).
•
Check the network cable and connections for defects. Replace
the defective cable if necessary.
Summary of Contents for EZ Connect
