-26-
No.EX
※※
-OMZ0016
Setting and Adjustment
Flow chart for operating the wireless system
Flow chart for using the wireless system
To use SMC wireless units (Base and Remotes), they need to be set up using an NFC reader/writer and the
I/O Configurator. A setup procedure using NFC is shown below.
Refer to the operation manual for each manufacturer for how to set the controller and the PLC.
Procedure 1 Preparation (PC application)
(1) Install the NFC reader/writer driver
* When using EXW1-NT1, refer to its operation manual. Otherwise,
refer to the operation manual for the I/O Configurator (NFC version).
(2) Install the I/O Configurator
*: Ver. 2.9.0 and later versions of the I/O Configurator are supported.
*: Refer to the explanation from p. 27 onward for an outline of the I/O Configurator.
*: Refer to the operation manual of the I/O Configurator (NFC version) for details of the I/O Configurator.
Procedure 2 Setting / installation of the wireless unit
(1) Setting parameters of Remotes (optional)
*: Change settings in Administrator mode in the I/O Configurator.
(2) CC-Link, system and frequency channel select function (F.C.S.) settings
of the Base
*: Change settings in Administrator mode in the I/O Configurator.
The frequency channel select function (F.C.S.) is optional.
(3) Register the Remote to the Base (pairing)
*: The Base and Remote need to be powered.
*: Change settings in Administrator mode in the I/O Configurator.
(4) Installation and wiring
Procedure 3 Connection to PLC
Note) Refer to the operation manual of the PLC manufacturer for connection to PLC and Configurator.
