- 13 -
< Applicable Auto switches >
Solid state auto switch---D-M9N
・
M9P
・
M9B
・
M9N
Ｖ・
M9PV
・
M9BV
D-M9NW
・
M9PW
・
M9BW
・
M9NW
Ｖ・
M9PWV
・
M9BWV
D-M9NA
・
M9PA
・
M9BA
・
M9NA
Ｖ・
M9PAV
・
M9BAV
Reed auto switch----------D-A90
・
A93
・
A96
・
A90V
・
A93V
・
A96V
Fig. 3 Mounting and movement of the auto switch
Mounting method of auto switch
(1) Set the mounting band for the auto switch roughly at the auto switch set position of the cylinder tube.
(2) Place the switch holder at the opening of (1).
(3) Face the switch bracket surface with a dent downward to place it on (2).
Set the auto switch mounting band so that the both ends of the band are positioned between the
switch bracket ribs.
For D-M9
□A(V), avoid mounting the switch bracket near the indicator LED. As the indicator LED
protrudes from the switch unit, mounting the switch bracket above the LED may cause damage to it.
(4) Insert the auto switch mounting screw (M3) included in accessories from the mounting hole of the
auto switch mounting band, inserting the through hole of the switch bracket. Then, screw the
mounting screw to M3 female screw of the auto switch mounting band.
(5) Tighten the auto switch mounting screw with specified tightening torque
（
0.6 to 0.7
Ｎ・ｍ）
.
(6) Insert the auto switch to the auto switch mounting groove of the switch holder (2).
(7) After checking the detecting position, tighten the mounting screw (M2.5) to fix the auto switch.
Tightening torque is 0.05 to 0.1Nm.
For the tightening of the mounting screws of auto switch, use a watchmaker's screwdriver with a
handle diameter of about 5 to 6 mm.
Auto switch position adjusting method
1) For fine adjustment, loosen the mounting screw (M2.5) and slide the switch within the mounting
groove of the auto switch holder.
2) Otherwise, loosen the mounting screw (M3) of the auto switch mounting band, and slide the switch
holder on the cylinder tube.
< Cautions for BM5 >
When removing the auto switch mounting screw after assembling the auto switch mounting band,
attention should be taken so that the switch bracket, auto switch mounting screw and auto switch
mounting band do not come off.
！
Caution
(1) Ensure that the tightening torque is within
the specified range.
(2) Make sure that auto switch mounting band is
not slanted.
Correct mounting
Incorrect mounting
Rib
The surface with dent
face downward
Protrusion
The surface with projections
face upward
Plate for
reinforcement
60
o
to 80
o
< Switch bracket >
