67
Then, if the wireless client wants to associate, it has to request to authenticate.
Appendix D FAQ and Troubleshooting
Reset to factory Default
There are 2 methods to reset to default.
Restore with RESET button
First, turn off the router and press the RESET button in. And then, power on the router and push
the RESET button down until the Status LED start flashing, then remove the finger. If LED flashes
about 8 times, the RESTORE process is completed. However, if LED flashes 2 times, repeat.
2.
Restore directly when the router power on
First, push the RESET button about 5 seconds (M1 will start flashing about 5 times), remove the
finger
. The RESTORE process is completed.
Summary of Contents for Barricade SMCWBR 14-GM
