25
the length of Pre-share key is from 8 to 63.
Key value shared by the RADIUS server and this router. This key value is consistent with the
key value in the RADIUS server.
WPA-PSK /WPA2-PSK
Select Encryption and Pre-share Key Mode. If you select HEX, you have to fill in 64
hexadecimal (0, 1, 2…8, 9, A, B…F) digits, if ASCII, the length of Pre-share key is from 8 to 63.
Fill in the key, Ex 12345678
WPA/WPA2
Check Box was used to switch the function of the WPA. When the WPA function is enabled, the
Wireless user must
authenticate
to this router first to use the Network service. RADIUS Server
IP address or the 802.1X server’s domain-name. Encryption and RADIUS Shared Key
If you select HEX, you have to fill in 64 hexadecimal (0, 1, 2…8, 9, A, B…F) digits, if ASCII,
the length of Pre-share key is from 8 to 63.
Key value shared by the RADIUS server and this router. This key value is consistent with the
key value in the RADIUS server.
WDS(Wireless Distribution System)
WDS operation as defined by the IEEE802.11 standard has been made available. Using WDS it
is possible to wirelessly connect Access Points, and in doing so extend a wired infrastructure to
locations where cabling is not possible or inefficient to implement.
How to setup and work:
AP 1: AP2:
AP3:
IP:192.168.2.1
IP:192.168.2.253
IP:192.168.2.252
Mac:00-50-18-00-0f-fe Mac:00-50-18-00-0f-fd
Mac:00-50-18-00-0f-fc
SSID: Default SSID: Default
SSID: Default
Channel:11 Channel: 11
Channel:11
DHCP Server: Enable
Summary of Contents for Barricade SMCWBR 14-GM
