![background image](http://html1.mh-extra.com/html/smc-networks/8612t-annexe-1/8612t-annexe-1_management-manual_1300701348.webp)
C
OMMAND
L
INE
I
NTERFACE
3-180
• If the target switch has also enabled LACP on the connected
ports, the trunk will be activated automatically.
• If more than four ports attached to the same target switch have
LACP enabled, the additional ports will be placed in standby
mode, and will only be enabled if one of the active links fails.
Example
The following shows LACP enabled on ports 10-11. Because LACP
has also been enabled on the ports at the other end of the links,
the
show interfaces status port-channel 1
command shows that
Trunk 1 has been established.
Console(config)#interface ethernet 1/10
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface ethernet 1/11
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface ethernet 1/9
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#exit
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type: 1000T
Mac address: 00-00-11-11-22-2C
Configuration:
Name:
Port admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full, 1000full,
Flow control: Disabled
Port security: Disabled
Port security action: None
Current status:
Created by: lacp
Link status: Up
Port operation status: Up
Operation speed-duplex: 1000full
Flow control type: None
Member Ports: Eth1/9, Eth1/10, Eth1/11,
Console#
b_mgmt.book Page 180 Tuesday, July 8, 2003 5:24 PM
Summary of Contents for 8612T - annexe 1
