SMC Networks 8126L2, Management Manual

Page: 322 / 502

Command Line Interface
4-80
4
Command Usage
• If you enable port security, the switch stops learning new MAC addresses on
the specified port when it has reached a configured maximum number. Only
incoming traffic with source addresses already stored in the dynamic or static
address table will be accepted.
• First use the port security max-mac-count command to set the number of
addresses, and then use the port security command to enable security on the
port.
• Use the no port security max-mac-count command to disable port security
and reset the maximum number of addresses to the default.
• You can also manually add secure addresses with the mac-address-table
static command.
• A secure port has the following restrictions:
- Cannot use port monitoring.
- Cannot be a multi-VLAN port.
- Cannot be connected to a network interconnection device.
- Cannot be a trunk port.
• If a port is disabled due to a security violation, it must be manually re-enabled
using the no shutdown command.
Example
The following example enables port security for port 5, and sets the response to a
security violation to issue a trap message:
Related Commands
shutdown (4-121)
mac-address-table static (4-140)
show mac-address-table (4-141)
Console(config)#interface ethernet 1/5
Console(config-if)#port security action trap