![background image](http://html1.mh-extra.com/html/smc-networks/7908vowbra2/7908vowbra2_user-manual_1300234024.webp)
I
NSTALLATION
2-8
Warning:
Do not plug a phone jack connector into an RJ-45 port. This
may damage the Barricade.
Note:
Use 100-ohm shielded or unshielded twisted-pair cable with RJ-45
connectors for all Ethernet ports. Category 5 cable is
recommended. Make sure each twisted-pair cable length does not
exceed 100 meters (328 feet).
Connect the Power Adapter
Plug the power adapter into the power socket on the rear of the Barricade,
and the other end into a power outlet.
Check the power indicator on the front panel is lit. If the power indicator is
not lit, refer to “Troubleshooting” on page A-1.
In case of a power input failure, the Barricade will automatically restart and
begin to operate once the input power is restored.
Wall-Mount Installation
There are two wall-mount holes at the bottom of the Barricade. Before
drilling two holes into the wall, make sure the holes are 175 mm apart.
1. Choose a suitable location for the Barricade.
Note:
It should be accessible for installing, cabling and maintaining the
device.
2. Measure the distance of the two wall-mount holes.
3. Drill two holes into the wall.
4. Insert a screw into each hole.
Note:
Leave 5 mm exposed of the screw head.
5. Attach the Barricade to the wall with two wall-mount slots, and then
slide the device down until the screws fit firmly into the slots of the
device.
Summary of Contents for 7908VOWBRA2
