![background image](http://html1.mh-extra.com/html/smc-networks/6826mpe/6826mpe_installation-manual_1300180052.webp)
I
NSTALLING
THE
S
WITCH
3-12
Connecting to a Power Source
To connect a switch to a power source:
1. Insert the power cable plug directly into the AC socket located at the
back of the switch.
Figure 3-8 Power Socket
2. Plug the other end of the cable into a grounded, 3-pin socket, AC
power source.
Note:
For international use, you may need to change the AC line cord.
You must use a line cord set that has been approved for the socket
type in your country.
3. Check the front-panel LED indicators as the device is powered on to
be sure the PWR LED is lit. If not, check that the power cable is
correctly plugged in.
4. If you have purchased a Redundant Power Supply, connect it to the
device and to an AC power source now, following the instructions
included with the package.
100-240V~
50/60Hz 8.0-2.0A
Summary of Contents for 6826MPE
