SMC Networks 6750L2, Installation Manual

Page: 44 / 78

I
NSTALLING THE
S
WITCH
3-6
Connecting to a Power Source
To connect a device to a power source:
1. Insert the power cable plug directly into the receptacle located at the
back of the device.
Figure 3-4. Power Receptacle
2. Plug the other end of the cable into a grounded, 3-pin socket.
Note:
For International use, you may need to change the AC line cord.
You must use a line cord set that has been approved for the
receptacle type in your country.
3. Check the front-panel LEDs as the device is powered on to be sure
the Power LED is lit. If not, check that the power cable is correctly
plugged in.
4. If you have purchased a Redundant Power Unit, connect it to the
device and to an AC power source now, following the instructions
included with the package.