![background image](http://html1.mh-extra.com/html/smc-networks/2870w-annexe-1/2870w-annexe-1_manual_1298928065.webp)
Troubleshooting
55
Troubleshooting
1. My PC won’t communicate with a PC or printer connected to
the EZ Connect™ g Wireless Ethernet Bridge.
•
Perform the following steps:
a)Verify if the PC or printer connected to the Wireless
Ethernet Bridge is on the same wireless network by
checking the IP configuration.
b)Verify if the SSID and other settings are the same for
all devices connected to the same wireless network.
c)If the wireless LAN settings are correct, verify all the
devices are on the same IP network.
Check the Ethernet crossover cable and make sure it is properly
connected and that the LINK/ACT LED is lit. If this LED is not lit,
confirm you are using a crossover Ethernet cable.
2. I cannot get my Ethernet-equipped device online through the
EZ Connect™ g Wireless Ethernet Bridge
•
Perform the following steps:
a)If using DHCP, verify that the DHCP server has two
available IP addresses – one for the SMC2870W and
one for your Ethernet-equipped device
b)If you have MAC Filtering/Access Control enabled on
your Access Point, you must put the MAC Address of
your SMC2870W into your AP’s list of allowed
clients. You can get the SMC2870W’s MAC Address
from the System Info page
Summary of Contents for 2870W - annexe 1
Page 1: ......
Page 2: ......
Page 8: ......
Page 38: ...Configuring Your Computer 28 4 Click OK and click Close to continue and save the changes...