![background image](http://html1.mh-extra.com/html/smc-networks/2870w-annexe-1/2870w-annexe-1_manual_1298928020.webp)
Hardware Installation
10
Hardware Installation
1. Select the Site – Choose a location for your Wireless Ethernet
Bridge. Usually, the best location is at the center of your
wireless coverage area, if possible within line-of-sight of all
wireless devices.
2. Place the Wireless Ethernet Bridge in a position that gives it
maximum coverage. Normally, the higher you place the
antenna, the better the performance.
3. Position the antennas in the desired positions. For more
effective coverage, position the antennas along different axes.
For example, try positioning the antennas around 45 to 90
degrees apart. (The antennas emit signals along the toroidal
plane – and thus provide more effective coverage when
positioned along different axes.)
4. If used in Wireless Bridge mode, connect the Ethernet cable
to the RJ-45 socket of the device will communicate wirelessly
with an access point.
5. If used in Access Point mode, connect the Ethernet cable –
The SMC2870W can be wired to an Ethernet network through
an Ethernet device such as a hub or a switch using category
3, 4, or 5 UTP Ethernet cable and an RJ-45 connector.
6. Connect the power cable – Connect the power adapter cable
to the 5 VDC power socket on the rear panel. Warning: Use
only the power adapter supplied with the SMC2870W.
7. Check the LED’s on the front of the unit to make sure the
adapter is turned on properly and the status is okay.
Summary of Contents for 2870W - annexe 1
Page 1: ......
Page 2: ......
Page 8: ......
Page 38: ...Configuring Your Computer 28 4 Click OK and click Close to continue and save the changes...