Pre-Injection
The Shift limiter can be programmed 'Stock' or 'Off'
Pre-Injection programmed "Off" disables the preliminary injection of the engine.
The adjusted parameters are stored in Smarty memory and used on next ECM programming.
Smarty asks the confirmation to program the ECM:
Smarty will read the serial number of your vehicle and the serial number of your ECM, then store
them into its onboard memory for future reference. From this moment on, Smarty will work only with
your vehicle until your vehicle is restored back to the stock settings by Smarty.
Press the ‘>’ key to begin the updating session.
If the connection cannot be established, Smarty asks you to switch off the ignition key:
Turn the ignition key to “OFF”. Press the ‘>’ key. Smarty will then ask you to switch the ignition
key “ON” in order to retry the connection:
Turn the ignition key to the “RUN” position. DO NOT START THE ENGINE.
Press the ‘>’ key to begin the updating session. You will see the following screen:
Smarty checks its memory content before sending the data to the truck. After a few seconds, a
numeric counter begins with the percentage of the transmitted software. At the end of the download
(when 100% is reached) Smarty will update the functional parameters of the ECM. The following
screen will appear:
During the updating session, Smarty can ask to Turn key OFF and Turn Key ON. Please follow these
instructions. DO NOT DISCONNECT Smarty before the updating session is completed.
At the end of the updating session, the following screen appears:
After a few seconds Smarty displays the following message:
Please unplug Smarty from the diagnostic port and turn the Key off for 15 seconds.
Remember to restore the STOCK software before returning your vehicle to a service center.
Page 8 of 16
