SmartWitness SVC400GPS-L, User Manual

Page: 69 / 90

69
set, check the SD EventRecord, select the
type
from “NONE or SmartWitness
(RESONANT is a specific type which should
not be used). After selecting the SD
EventRecordType, you can choose to leave
the SD EventRecord on by leaving the check
or off by unchecking.
If SD EventRecord Type is set to NONE, can
select from four options: NoRecord ,
Normal, Event, or Event
- If NoRecord is selected no video nor audio
data will be saved on the HDD.
- If “Normal” is selected, video and audio
data will be recorded at the set FPS
continuously.
- If “Event” is selected, the device will only
record when the Events, defined in the
Event tab, occurs.
- If “ Event” is selected, normal
recording at 1 FPS will be on the HDD (or
SSD) but when there is an Event, defined in
the Event tab, the recording will switch to
the set FPS.
If SD EventRecord Type is set to
SmartWitness, can select from four options:
NoRecord or Panic.
- If “ Panic” is selected, normal
recording at 1 FPS will be on the HDD (or
SSD) but when there is an Event, defined in
the Event tab, the recording will switch to
the set FPS.
Audio Check if you wish to include audio for this
channel
VideoType Select from NTSC or PAL
Resolution Select from “D1(704*480), HD1(704*240),
CIF(352*240)”
Quality Select from “Normal, High, Super”.
EventRecord Pre - Select from ”N/A or 1 sec
～
5 sec”.
- If ”N/A” is selected, there will be no
recordings before the event.
- Depending on the set seconds: “1 ~ 5 “,
for every event there will the set amount of
pre-recorded data.
Post
- Select from ”N/A or 1 sec
～
5 sec”.
- If ”N/A” is selected, there will be no
recordings after the event.
- Depending on the set seconds: “1 ~ 5 “,
for every event there will the set amount of
post-recorded data.
Pre and Post times are only valid in event recording mode.
Password An additional password can be set for the recorded data using a
4 digit password from 1000 ~ 9999. If a password is set, keep
a record in a safe place. Without the password, you will not be
able to view the data.
Overwrite If this box is checked, when the HDD or SSD is full, it will start
overwriting from the oldest data. If the box is not checked, the