ASSEMBLE SIDE PANELS
7
TOP PLATE
BOTTOM PLATE
1810mm
1833mm
TOP PLATE
15mm
15mm
TOP PLATE
BOTTOM PLATE
1810mm
1833mm
Second Side
Panel
BOTTOM PLATE
TOP PLATE
SELECT:
4 x 1850 Wall Sheets
2 x 1.020 Top Plates (Red)
2 x 1.020 Bottom Plates (Green)
48 x 30mm Galv Clouts
4 x Rivets
STEP 1:
Lay out 1 x Top Plate and 1 x Bottom Plate on a flat surface as shown
(corner cutouts to face outwards).
Measurements between Top and
Bottom plates are critical to ensure wall panels fit together.
STEP 2:
Place 2 x 1.850 wall sheets on top of timber plates, with sheets
flush with each other.
Rivet sheets together on overlaps as shown.
STEP 3:
Nail wall sheets to the Top Plate at each end making
sure that the top of the sheets are flush with the top of
the Top Plate and the sides of the wall sheet overhang
the Top Plate by approx 15mm as shown.
Check that the Top Plate is straight then nail along the
wall sheet to the Top Plate, two clouts per pan (see
fig. 1
).
STEP 4:
Nail the wall sheets to the Bottom Plate at each end ensuring each
side of wall sheets overhangs the end of Bottom Plate by 15mm.
Check that the distance between the Top and Bottom Plates is
correct. (As per diagram in step 1)
Check that the Bottom Plate is straight then nail the wall sheets to
the Bottom Plate, two clouts per pan (see
fig. 1
).
Repeat with second side panel ensuring Top Plate is positioned in
the OPPOSITE direction to the first side panel, as shown.
fig.1
RIB
PAN
CLOUT
TIMBER PLATE
Std Shed —
Bottom Plate will protrude below wall
sheet by approximately 10mm.
Raised base plate shed —
Wall sheet will protrude
below the Bottom Plate by 20mm
.
IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER
BASE PLATE –READ THE FOLLOWING;
For sheds with Raised Base Plate option only (see page 5), deduct
30mm from measurement shown between Top and Bottom Plates on
all wall panels, so cladding protrudes 20mm below bottom plate
.
TOP PLATE
BOTTOM PLATE
15mm
15mm
1810mm
1833mm
15mm
RIVET
RIVET
