Smartsafe Tech iSmartEV P01, User Manual

Page: 3 / 40

iSmartEV P01 User Manual www.newsmartsafe.com
III
6. High voltage debugging must be carried out under the premise of good low
voltage debugging, so as to determine whether the battery has leakage. If there is
leakage, it should be checked in time, and high voltage debugging cannot be
carried out.
7. During disassembling and installing the power battery pack assembly; wrap the
high-voltage wiring harness connector connected to the high-voltage distribution
box with insulation tape. Do not damage the wiring harness during disassembly
and installation to avoid electric shock.
8. During repairing or replacing parts that pass through the sheet metal holes of
the body, such as high-pressure wiring harnesses and tubing, pay attention to
check whether the protection with the sheet metal of the body is normal to avoid
the wear of the wiring harnesses and tubing
NOTES
1. Maintain a safe environment for vehicle testing at all times.
2. Do not operate the detection equipment while driving the vehicle to avoid
distraction and causing an accident.
3. Before starting the engine, you should pull the handbrake, especially the front
wheel, and put the shift lever in neutral (manual transmission) or [P] gear
(automatic transmission) so as not to start the engine and make the vehicle injure
people.
4. The exhaust gas from the engine contains a variety of toxic compounds (such
as hydrocarbons, carbon monoxide, nitrogen oxides, etc.), which will lead to slow
response and even serious personal injury or death. The vehicle under test
should be parked in a well-ventilated place during operation.
5. Take extreme care when working around ignition coils, distributor caps,
ignition lines and plugs. These components generate dangerous voltages when
the engine is running.
6. To avoid damaging the testing equipment or generating incorrect data, please
ensure that the vehicle battery is fully charged and that the connection of the
vehicle diagnostic seat is clean and safe.
7. The vehicle battery liquid contains sulfuric acid, sulfuric acid is corrosive to the
skin, so you should avoid direct contact between the battery liquid and the skin
during the operation, especially do not splash it into the eyes, and do not put it
close to the fire.
8. Keep clothing, hair, hands, tools, testers, etc. away from running or hot engine
parts.
9. Please use the charger that comes with it. The Company will not be