CONFIDENTIAL AND PROPRIETARY
The Information contained in this document shall remain the sole exclusive property of s.m.s smart microwave sensors GmbH and shall not
be disclosed by the recipient to third parties without prior consent of s.m.s smart microwave sensors GmbH in writing.
Getting_started_Guide
I
Page 8
of 16
I
January 30, 2019
3.3
Installation of the sensors
Typically, the automotive/industrial radar sensors should be installed at the same height
level as the targets to be detected. Please make sure that the radar beam covers the zone
of interest as good as possible by adjusting the azimuth and elevation angle. For
installations in a car, a mounting height between 50cm and 80cm over ground with an
elevation angle of 0 degree is recommended
3.3.1
UMRR-11 T132
The connector of the UMRR-11 is placed on the back of the sensor above the label. The
origin of the coordinate system is in the middle of the sensor (zero axis). The azimuth angle
refers to the horizontal axis, whereas the elevation angle refers to the vertical axis as
indicated in Picture 5. All values are provided relatively with regard to the mounting position.
Picture 5: Coordinate system relative to UMRR-11 T132
sensor top
positive
azimuth
angles
positive
elevation
angles
