HRC200 Industrial Remote Control User Manual Page 9 of 16
Table 6 Communication Channel Configuration Steps
Step
Description
1
Turn the bottom screw cover anticlockwise to open the base.
2
Change the middle four jumper cap positions to configure the
communication channel and replace the battery at the same time.
3
Turn the bottom screw cover clockwise to close the base.
The receiver configures the communication channel via dial switch. It is 1 when the dial switch is
set to ON position, otherwise it is 0. The default dial switch position is 1111 (515MHz).
Table 7 Communication Channels
No.
Channel Frequency (MHz)
1
0001
445
2
0010
450
3
0011
455
4
0100
460
5
0101
465
6
0110
470
7
0111
475
8
1000
480
9
1001
475
10
1010
485
11
1011
490
12
1100
495
13
1101
500
14
1110
505
15
1111
515
It is 1 when the dial switch is set to ON position, otherwise it is 0.
NOTE:
When the dial switch is configured as 0000, it is configuration mode (refer to 4.1).
4.4
PAIRING
Table 8 Pairing Description
Method
Process
Method 1:
Remote control waits
for receiver pairing.
1.
Turn the remote control and receiver to the same channel. (see the
communication channel configuration, default channel is 515MHz.)
2.
Turn on the remote control power, its power indicator keeps on. Long
press F2 key 6s, all indicators are flashing yellow, which means entering
pairing mode. Press F2 key again during LoRa pairing can cancel pair.
3.
Turn on the receiver power, POWER indicator keeps on. Insert a slender
needle less than 3.5mm in diameter into the PAIR hole vertically, then long
press PAIR key 6s.
