HGM6100U Series Automatic Control Module
HGM6100U Automatic Genset Controller ISSUE 2014-10-28 Version 1.2 Page 20 of 39
7 PARAMETER RANGE AND DEFINITION
7.1 PARAMETER CONTENT AND RANGE TABLE (TABLE 1)
No.
Items
Range
Default
Description
1
Mains
Normal
Delay
(0-3600)s
10
The delay from abnormal to
normal or from normal to
abnormal. It used for ATS
(automatic transfer switch)
control.
2
Mains Abnormal
Delay
(0-3600)s
5
3
Mains
Under
Voltage
(30-620)V
184
When mains voltage is under
the point, mains under voltage
active. When the value is 30,
mains under voltage disabled.
4
Mains
Over
Voltage
(30-620)V
276
When
mains
voltage
is
greater than the point, mains
over voltage active. When the
point is 620V, mains over
voltage disabled.
5
Transfer
Rest
Time
(0-99.9)s
1.0
It’s the delay from mains open
to generator closed or from
generator open to mains
closed.
6
Start Delay
(0-3600)s
1
Time from mains abnormal or
remote start signal is active to
start genset.
7
Stop Delay
(0-3600)s
1
Time from mains normal or
remote start signal is inactive
to genset stop.
8
Start Times
(1-10) times
3
When engine start failure, it
’
s
the maximum cranking times.
When setting crank times out,
controller
send
start
fail
signal.
9
Preheat Time
(0-300)s
0
Time of pre-powering heat
plug before starter is powered
up.
10
Crank Time
(3-60)s
8
Time of starter power up each
time.
11
Crank Rest Time
(3-60)s
10
The second waiting time
before power up when engine
start fail.
12
Safe
Running
Time
(1-60)s
10
Alarm for low oil pressure,
high temp, under speed,
under
frequency
/voltage,
charge fail are all inactive.
