Preface
ix
3
With your Macintosh computer turned off, unplug your keyboard connector from the
keyboard port. Next, connect the power plug end of the supplied SMART Keyboard
Adapter to the power plug on the long DB9 connector and the other end to the vacated
keyboard port. Finally, reconnect the keyboard connector to the SMART Keyboard
Adapter.
NOTE
: If your Macintosh computer isn’t equipped with a keyboard port, connect an
external power supply to the power plug socket on the long DB9 connector. This external
power supply must have the following characteristics:
•
2.1 mm inner diameter — positive center post
•
5.5 mm outer diameter — negative outer barrel
•
6V DC to 12V DC output
•
minimum 200 mA output
4
Turn on your Macintosh computer.
NOTE
: The Ready Light on the Pen Tray will turn red when you turn on your Macintosh
computer. This indicates it’s receiving power from your keyboard port or external
power supply.
5
Insert the SMART Board software CD into your CD-ROM drive. The CD will
automatically launch the installation program. Follow the on-screen instructions.
Immediately following SMART Board software installation, you’ll notice the Ready Light
on the Pen Tray turns from red to green. This indicates that the interactive whiteboard
is now fully touch sensitive.
Power Plug Socket
Long DB9
Connector
To Keyboard
Port
To Keyboard
Connector
To Serial
Adapter
Ready Light
SMART Keyboard Adapter
