2.3 Smartbell Overview
8
1. Camera
2. Speaker
3. Microphone
4. IR LEDs
7. Doorbell
5. If you will using a wired connection to your router,
run your ethernet cable through the hole and connect
to the back of the smartbell. Attach as shown above.
If you are connecting wireless, skip to step 6.
10. Now, plug the power supply into a power source.
Your smartbell is now ready to configure using the
smartbell app. Proceed to Section 3 ‘App Setup’.
8. Insert your Micro SD Card (if you have purchased
one) to enable recording.
9. Put the screw cap covers in place over the screws at
the back of the smartbell. Attach the smartbell to the
bracket. Secure the unit to the bracket using the provided
screw and place at the bottom of the unit. Then use the
cap to cover (shown above, right).
7. If you choose a wired connection to your router/home
plug/switch, run your ethernet cable through the hole
and connect to the back of the smartbell. Attach as
shown above. If you choose a wireless connection skip
this step and proceed to step 6.
6. Name Tag
5. PIR Sensor
