Basic Operation
8
4.5
Insert Batteries of Remote Control
This describes the steps for inserting new
batteries of the remote control or for replac-
ing empty batteries:
1. Open the battery compartment on the
bottom side of the remote control. Remove
the cover of the battery compartment.
2. Place the two batteries 1.5 V (type: AAA).
Ensure correct polarity!
3. Close the battery compartment
Replace the batteries if certain
remote control functions are not
performed any more or are per-
formed incorrectly.
When replacing batteries, al-
ways ensure that all batteries
are replaced.
5
Basic Operation
This chapter describes the required steps to be
able to use the offer of radio and TV channels
provided via wide-band cable
1F
2
.
5.1
First Comissioning
5.1.1
Switch on Receiver
1. Switch on all connected devices.
2. Ensure that the correct AV input is selected
at the TV set (i.e. that the signals from the
receiver are displayed).
3. Connect the mains plug to the power outlet
to switch on the receiver.
5.1.2
Welcome
The default
Language
(Sprache)
is
Deutsch.
The default
Country (Land)
is
Deutschland.
Ensure that the entries are correct; you
may change the values, if required.
2
The radio and TV programs available via wide-band
cable depend on your respective cable network
provider.
Using the keys
PR+
and
PR
, go to the key
Start search
and press
OK
to start auto-
matic channel search.
5.1.3
Auto Scan
The TV cable is now scanned for any available
channels. Such search then creates the chan-
nel lists with
TV Channels
and
Radio Chan-
nels
.
1. After end of search, please confirm the
corresponding message by pressing
OK
.
2. Leave the menu by pressing the
EXIT
key
until the screen shows the TV picture.
The menu item
Auto search
can
always be accessed via the menu
Installation
.
5.2
Select Operation Mode
TV is the operation mode after first
switching-on of the receiver (or after
restoration of factory settings).
You can select between the operation
modes TV (TV channels) and RADIO (radio
channels) as follows:
Press the key
TV/RADIO
on the remote
control.
Press again the key
TV/RADIO
to return to
the previous operation mode.
5.3
Call/Leave Menu
To call the menu, press the key
MENU
(of
the remote control or at the receiver). The
menu is called.
Press the
EXIT
key to leave the menu or to
go back one step.
In could be possible that you have
to press
EXIT
several times to go
back to TV mode.
