3
INSTALLATION
The machine is supplied factory lubricated and
ready to run. It can be positioned on any substantial
work surface or bench which is capable of
supporting a load of 30kg. The transportation
should require two people. Please see Figure 1.
ELECTRICAL CONNECTION
Before connecting this machine to the
electrical supply, please check the details on the
rating plate (located on the rear of the machine)
corresponding to the details of your electrical
connection. The mixer is supplied with a trailing
lead fitted with a molded plug. If the style of plug is
unsuitable for the socket you plan to use, the plug
must be cut off and replaced with an appropriate
plug.
The mixer should be plugged into a switched
socket which isolates all poles and has a minimum
contact clearance of 3mm and located close to the
mixer for use in an emergency and to facilitate
servicing. (max.2 meters of cable) The machine
must be incorporated into a potential equalization
system. The leakage current for this appliance is no
greater than 1mA/KW. If the electrical supply cable
to the machine becomes damaged, it must be
replaced by a qualified electrician using cable
which is 0.75 or higher and suitable for a 1/4HP
motor load. The ground wire is fixed to the machine
and this connection must be kept intact.
The mixer
MUST be grounded.
- The minimum requirement for all electrical
equipment is correct operation between air
temperature of +5°C and +4°C.
- Electrical equipment is capable of operating
correctly when the relative humidity does not
exceeding 95% at a maximum temperature of
+40°C.
- Electrical equipment is capable of operating
correctly at altitude up to 1000m.
- Electrical equipment is designed to withstand to
protected against the effects of transportation, and
storage temperature within a range of -25°C to
+55°C and for short periods not exceeding 24h at
up to +70°C.
BEFORE USING THE MIXER
Before using the mixer, please ensure that all
users are familiar with the correct operation of the
machine. In particular, care should be taken to
ensure that the bowl and mixing tools are correctly
fitted and the bowl cradle is in the raised position
prior to starting the machine.
SAFETY AT WORK
Never place your hand or any kitchen utensil
into the bowl when the mixer is in operation.
Please isolate the machine from the electrical
supply by removing the plug from the socket before
cleaning or dismantling.
A notice advising operators of the safe use of
this mixer is attached to the machine.
