5 Mounting
SMA America, LLC
32
SB3-5TLUS22-IA-en-10
Installation Manual
1. Screw the DC Disconnect retainer onto the inverter
wall mounting bracket using the screws and
washers supplied. In doing so, tighten the two
upper screws (M5x12) from the rear and the lower
(M5x8) from the front.
2. Align the wall mounting bracket horizontally at the mounting site.
4. Mark the position of the drill holes using the wall mounting bracket and screw the wall mounting
bracket onto the wall using the screws and washers.
• For mounting on a stone wall, use 1 hole on the
right-hand and left-hand side and the lower hole
in the wall mounting bracket.
• For mounting on a stand or post in a drywall,
use the two holes at the center.
3.
Danger to life due to electric shock or explosion if you drill into cables
There may be gas pipes or electric cables behind the mounting points which could be damaged
when you drill the holes for the wall mounting bracket.
• Make sure that there are no supply lines behind the mounting points.
