8
FLUSHING WATER LINES
Note: Valve is shipped with flow adjustment turned off. Requires sensor assembly.
A
Ensure water is shut off: use adjustment tool to turn activation
assembly fully clockwise.
B
Verify valve is not pressurized
i. connect solenoid to sensor assembly.
ii. Connect battery pack.
iii. Press override button.
Disconnect Solenoid from Sensor
assembly
Press in activation assembly.
E
Squeeze tabs on Collar and pull
out.
F
Attached provided screws to
activation assembly. Pull to
remove assembly
S
Remove conical spring. Do not
discard!
Remove piston assembly by
pulling straight out. If unable to
grip piston, remove screw from
activation assembly and insert
into center hole of piston.
J
Reinstall activation assembly
and press until fully seated.
Remove screws.
CLOSE
E1
E2
B2
B1
C
B3
D
D
G
H
G1
OPEN
CLOSE
G
Reinstall Collar. Collar will
spin freely in valve body when
properly installed.
H
Using adjustment tool, turn
activation assembly counter
clockwise to open flow of water
through the valve.
Push in activation assembly.
Squeeze tabs on Collar and pull
out.
I
K
M
L
Reinstall piston. Insert smaller sized end first until fully seated.
Reinstall conical spring, small end first, into piston.
Reinstall activation assembly and press until fully seated.
Reinstall orange collar securely. Collar will spin freely in valve body
when properly installed.
Adjust flow rate of valve as described in Section ADJUSTING FLOW
N
T
P
Q
R
CLOSE
E1
E2
B2
B1
C
B3
D
D
C
D
CLOSE
E1
E2
B2
B1
C
B3
D
D
CLOSE
E1
E2
B2
B1
C
B3
D
D
G
H
G1
OPEN
CLOSE
G
H
G1
OPEN
CLOSE
G
H
G1
OPEN
CLOSE
Once lines are flushed clear, turn
activation assembly clockwise to
shut off water.
G
H
G1
OPEN
CLOSE
N2
N1
M
M
R
S
P
Q
N2
N1
M
M
R
S
P
Q
