10
b: Put the evaporator filter screen into warm water with neutral detergent (about 40
℃
/104
℉
) and dry it in
the shade after rinsing clean.
B: Clean the lower filter screen frame
a: Hold the handle of the air inlet filter screen frame, and pull it outward gently to remove it.
b: Put the filter screen into warm water with neutral detergent (about 40
℃
/ 104
℉
) and dry it in the shade
after rinsing clean.
End of Season Maintenance
1.
Pull out the plug from the drainage hole and empty the internal tank. You can also drain the water by
leaning the unit.
2.
Then switch the unit to low fan mode.
3.
Keep the unit in this mode for half day - until the conduit is dried. Doing this helps to keep the inside of the
unit dry and prevents mold developing
4.
Turn off the unit and pull out the plug.
5.
Coil the wire and bind it together, then put it into the accessories space.
6.
Separate the air-exhaust pipe and store it safely.
7.
Cover the unit and keep it in a dry place.
8.
Take the batteries out of remote control and store or dispose, them safely
Keep all accessories with the unit ready for next season.
Troubleshooting
Do not repair or disassemble the air conditioning. Unqualified repair will invalidate the warranty and
may lead to failure, causing injuries and property damage. Only use it as directed in this user manual
and only perform operations advised here.
Problems
Reasons
Solutions
The air
conditioning
does not work.
There is no electricity.
Turn it on after connecting it to a socket with
electricity.
The overflow indicator displays "FL".
Discharge the water inside.
The ambient temperature is too low
or too high
Only use to use the machine within
temperature range of 7-35
℃
(44-95
℉
).
In cooling mode, the room
temperature is lower than the set
temperature; in heating mode, the
room temperature is higher than the
set temperature.
Change the set temperature.
In dehumidification mode, the
ambient temperature is low.
The machine is placed in a room with an
ambient temperature of greater than 17
℃
.
(62
℉
).
The cooling or
heating effect is
not good
There is direct sunlight.
Use curtains to reduce the direct sun heat
Doors or windows are open; there are
a lot of people; or in cooling mode,
there are other sources of heat (e.g.
fridges)
Close doors and windows; increase air
conditioning power
The filter screen is dirty.
Clean or replace the filter screen.
The air inlet or outlet is blocked.
Clear obstructions; make sure venting is
correct as described in this user manual and
hose is not bent
Loud Noise
The air conditioning is not placed on a
flat surface.
Put the air conditioning on a flat and hard
place (to reduce noise).
Compressor
does not work.
Overheat protection starts.
Wait for 3 minutes until the temperature is
lowered, and then restart the machine.
