12
5926
19
2021
-
SXP35 & SXP50
SX Spacer
Follow the installation of the SX thruster in the
Motor Installation
to step 3
.
see next page
1. Defi ne the location to install the thruster.
(NB: Ensure the thruster does not protrude past the transom profi le on any side and there is no
obstruction to the thrusters water flow. Also, check internally the thruster will not obstruct any objects.)
2. Mark the locations of the three drill holes using the defi ned measurements in this manual or from a template.
(NB: Maximum hull thickness is
50mm including optional spacer or 150mm for extended hull thickness models.)
3. Drill main hole, then two support bolt holes. Clean the area from dust for installation of the thruster.
(NB: Hull holes must be drilled fi rst before
attaching the spacer as the top support holes are larger than the spacers.)
---------
4. Drill out the two support bolt holes in the spacer.
5. Apply MS Polymer sealant or equal to the back surface face of the spacer.
6. Place the spacer to the hull.
Continue the installation of the SX thruster from step 4 in the
Motor Installation.
MC_0074
!
Please refer to the graphic for special considerations relating to your model
!
IMPORTANT
If using the 50mm spacer ensure you have the extended tube SX model.
MG_0262
Hull
Hull
12mm
Spacer
Apply MS Polymer sealant or
equal to back surface face
50mm
Spacer
Drill
8.5 / 9 mm
Drill
8.5 / 9 mm
4
6
5
IMPORTANT
The spacer and hull have different hole
diameters for the support bolts. This is to
allow the compression rings to be inserted
into the hull only.
The spacer and hull for the main tube have
the same hole diameter so compression
rings can be inserted for the total length of
the hole.
Compression
ring
Compression
ring
