Sleipner PJC421, User Manual, Page: 25 / 52

25
6770 2 2021
-
PJC421 & PJC422
TP-35 Control Panel Top Mount Installation
TP-35 Top Mount installation.
1. Place the supplied cut-out template on the desired installation location.
2. Cut out the area according to the template.
3. Place the gasket to the back face of the panel. If the front surface around your cut out is jagged or chipped, use a sealant to assist the gasket.
4. Plug cables into the connectors at the rear of the control panel. (NB: Access to the back of the panel my be impossible after installation.)
5. Insert the control panel in place and fasten screws.
6. Mount cover frame
MC_0395
TP-35 Control Panel Flush Mount Installation
TP-35 Flush Mount installation.
1. Place the supplied cut-out template on the desired location.
2. Cut out and mill the marked area on the template. Use a sealant on the milled surface to protect against water ingress around the panel.
3. Plug cables into the connectors at the rear of the control panel.
Flush mount installations can be installed in multipliable ways. Two options are using fastening bolts or with a rear harness to hold the TP-35 in place.
4a. On the rear face secure four studs in the milled area using the template as a guide. (NB: How to secure these studs will depend on the material of
the dashboard.) Insert the control panel in place and fasten with a washer/ nut. (NB: Fastening bolts, washers or nuts are not included.)
4b. Insert the control panel in place. Create fastening brackets to secure the TP-35 in place on the rear face of the dashboard. (NB: Fastening
brackets is not included and must be customized by the installer.)
MC_0395
MG_0465
1
2
3
4a
4b
Front surface
Back surface
Back surface
Front surface
Milling area.
Apply sealant on
the milled surface.
*Optional
3.5mm
9mm
X1 Joystick: Required .
Connect cable from joystick
X2 S-Link: Required .
Connect cable from S-Link bus
X3 I/O: Optional
See Detailed IO Description
section for more information.