12
SE 50/140S ignition protected thruster assembly
version 1.0.0 - 2017
Fitting propeller
EN
1. SE50/140S IP:
Push the propeller (3) onto the shaft, carefully rotate the propeller shaft until the drive pin (4) aligns and moves into the slot/groove in the propeller
hub. There should be almost no gap (approximately 1mm) between the propeller hub and the gear house.
Fig 1.
2. Place the washer (2) on the propeller shaft and then tighten the lock-nut (1) on the propeller shaft.
Fig 2.
NOTE! Ensure the propeller turns freely.
Fig. 1
Fig. 2
