16
music:
pq
Enter the folder with music files. Use the
pq
to select a file and press
u
or
OK
to start playback. To stop playback press
3
.
pictures:
pq
Enter the folder with picture files. Use
pq
to select a picture. If the format is
supported it shows the picture in the small picture-in-picture screen. Press
OK
to watch it in full screen mode.
Red
Option:
Before the playback of a picture in full screen, you can setup a slideshow/
diashow. Press the
Red
button
Option
to enter the sub option menu
Slide
change Time
. Select time of the slide show or switch this function off. After
you select a time, press
OK
and show starts to play. Press the
button to
stop.
7.4.2 storage device setup
This option shows relevant information about the connected USB device. In this menu you can also
format your USB storage device and safely remove.
Select
Storage Device Setup
in the
Multimedia
menu and press
OK
to enter.
Now you will see all details as free and used space sizes and used file system.
Press the
Red
Safely Remove
button and press
OK
to safely disconnect the USB device. The receiver will
display a message indicating that you can now safely remove your storage device from the receiver.
Press the
bLue
Format USB Device
button to format the connected USB device.
Please, enter your PIN code to access this menu and press
OK
to start formatting.
Press
to leave this menu.
nOTe:
After performing the
Safely Remove
function, the USB device is no longer
accessible by your receiver. To gain access to you’re the storage device
again, re-insert it or switch the receiver to standby and on again.
WaRning:
Formatting will permanently delete ALL data stored on the connected
device. Always make backups of data on your USB storage device before
using it with this receiver.
SKYWORTH will not take responsibility for any loss of information or
circumstances caused by loss of information.
nOTe:
It is possible to use USB storage devices already formatted in NTFS.
* Playback of files cannot be guaranteed although extensions are listed, as it depends on codec, data bit rate and resolution used (all MPEG
codec formats are supported).
7.5 network
This menu consists of the following submenus:
RSS
,
Weather
and
IP Settings
. First connect a CAT5E
(or higher quality) cable to the RJ-45 (ETHERNET) port of your receiver and ensure the other end is
connected to the internet accordingly. If there are questions or problems with the internet connection,
we recommend you to check details via the support or helpline of your internet provider.
Before you start to use the Internet functions please check the setup of the Internet connection via
IP
Settings
menu and confirm
SET
with
OK
. Usually the Internet connection should now been established
without any problem and ready to use. A message will inform you if the connection has been setup
successfully or not, use
OK
to confirm and press
9
to leave this menu.
