___________________________________________________________________________________________________________
REV 6/7/11 Page 7 of 14
Skytech 3301P BE
OVERRIDE will disappear.
3. To cancel OVERRIDE or HOLD, press the SET button.
TIME OF DAY DISPLAY
1
To check the current TIME of day, press the TIMER/TIME
button on the transmitter for less than 1 second. The
current TIME of day will appear in the TIME/TEMP frame
replacing the temperature reading.
2
The TEMPERATURE will reappear in 15 seconds, or you
can press the SET button to cancel the display of the time.
SETTING THE COUNTDOWN TIMER
This remote control can operate with a built-in, countdown
timer when the transmitter is in the ON or THERMO mode
(THERMO or ON must be displayed on the LCD screen). DO
NOT operate in PROGRAM MODE, as times are pre-
programmed into the transmitter.
1
Press the TIMER/TIME button on the transmitter for more
than 2 seconds. The word TIMER and 0:15 flash on the
LCD screen.
2
Press the UP or DOWN button on the transmitter to begin
advancing through each of the countdown time options.
Available countdown times are 15 min., 30 min, 45 min, 1
hr, 1 hr 30 min, 2 hr, 2 hr 30 min, and each additional half
hour up to nine hours.
3
To set the TIMER press the SET button on the transmitter.
If the system is ON, it will remain on until the “timer” has
expired. If the system is in the THERMO mode, it will
cancel ON and OFF, as the room temperature requires
until the “timer time” has expired.
4
To cancel the TIMER operation, press the TIME/RTIME
button for more than 2 seconds.
OPERATIONAL NOTE: When the TIMER is used in the THERMO mode, the THERMO operation will discontinue only when the
“countdown time” has expired.
LOW/BATTERY INDICATOR
The word LOW outlined by a battery on the left side of the LCD screen will appear when battery power has
dropped significantly. At this time, approximately two weeks of battery power remains until the transmitter
may experience partial or complete loss of functions.
NOTE: A reversed battery will activate the LOW battery icon.
TRANSMITTER
OPERATING SAFETY MONITORS: SYSTEMS SHUTDOWN
The SKYTECH remote control operates on RF (radio frequency) signals that are sent by the TRANSMITTER (remote) to the
RECEIVER that operates the appliance. It is recommended that the TRANSMITTER always be located within the 20 foot operating
range, preferably in the same room in which the appliance is located.
THERMO UPDATING FEATURE –TRANSMITTER – (T/S –TX)
This SKYTECH remote control has a THERMO UPDATING Feature built into its software. The THERMO UPDATING Feature operates
in the following manner, but only in the THERMO and PROGRAM MODES:
The transmitter normally reads the ROOM temperature every 2 minutes checking the ROOM temperature against the SET temperature
it sends a signal to the receiver.
TEMP
SET
WE
THERMO
HOLD
ON
FLAME
TIMER
1
2
3
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
TIME
TU
THERMO
ON
FLAME
PM
2
1
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
f i r e - p a r t s . c o m
