___________________________________________________________________________________________________________
REV 6/7/11 Page 12 of 14
Skytech 3301P BE
MODE button on the transmitter. A change in the beeping pattern, at the receiver indicates the transmitter’s code has been
programmed into the receiver.
5. Make sure the transmitter is within the 15’-20’ range of the receiver.
6. Positioning of the receiver is important. If the receiver is “enclosed” in a metal surround, the operation of the receiver may be
affected as noted below. Reposition the receiver to improve operating range. If the receiver is “enclosed” in a metal surround, this
can:
•
Cause the RF signal to get lost and not communicate with the receiver.
•
Cause the working distance to be shorter than normal.
NOTE: A receiver located in an area, where the ambient temperature inside the case exceeds 160
0
F, will cause THERMO-
SAFETY feature to cut in, requiring you to reposition the receiver to stop the warning beeps, and to “reset” the receiver’s operation.
BATTERY LIFE
Life expectancy of alkaline batteries in the SKYTECH 3301P BE should be at least 12 months. Replace all batteries annually. When
the Transmitter no longer operates the receiver from a distance it did previously (i.e., the transmitter’s range has decreased) or the
remote receiver does not function at all, the batteries should be checked in the transmitter. The Transmitter should operate with as little
as 2.5 volts of battery power, measuring at the (2) 1.5-volt batteries.
SPECIFICATIONS
BATTERIES: Transmitter 3V- 2 ea. AAA 1.5V, Alkaline
Remote Receiver (NO BATTERIES) FCC ID No.’s: transmitter –(K9L3301TX); receiver – (K9L3301TX)
Operating Frequency: 303.8MHZ Canadian IC ID No.’s: transmitter – 2439-3301TX; receiver – 2439-102-
760A
FOR TECHNICAL
U.S. INQUIRIES
CANADIAN INQUIRIES
SERVICE, CALL:
888/672-8929 or
877-472-3923
260/459-1703
Website: skytechsystem.com
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
f i r e - p a r t s . c o m
