50. Using medium CA, glue 2-5/8” blocks to
the inboard end of the trailing edge as
shown on plan. Insure you don’t get any
glue on the torque rod assembly.
Note:
You can use a light coat of oil on the torque
rod assembly to keep any excess CA from stick-
ing.
49. Draw a center line on each aileron and lay
out location of the hinges and aft facing
torque rod end. Drill a 3/32” hole and cut a
groove for the torque rod as was done on
the elevator halves. Cut the slots for
hinges in the ailerons and wing trailing
edge. Install aileron hinges and aileron.
Do
not glue hinges or torque rod until covering
is completed.
51. Glue two 1” tapered trailing edge pieces to
the outboard end of the wing trailing edge
with medium CA.
52. Block sand aileron and trailing edge pieces
to blend smoothly with wing sheeting.
Note:
To make sanding the aileron easier, tack it
to the wing TE with a couple drops of thin CA.
53. Remove ailerons and bevel aileron leading
edge as shown on plan.
54. Align and glue WT wingtip blocks in place
flat against R11 using medium CA.
12
