1
Permanent Wiring - Hardwire the Opener
5
Connect the conduit to the opener with the proper termination
Connect conduit wiring to
opener wiring with wire
nuts (Not Provided).
Install the bottom cover
and screws.
Green – Ground
White – Neutral
Black – Hot
INSTALL SAFETY BEAM SENSOR
1
1
Identify the Transmitter and the
Receiver
Mounting the Sensor on the Door Track
1
2
Important Information: The safety beam sensor can detect obstacle in the
path of its invisible beam. When the beam is obstructed while the door is
closing, the door will stop immediately and reverse to the fully open position,
and the opener lights will flash. It is important to ensure the invisible infrared
beam must be unobstructed by any part of the garage door, door tracks,
other hardware or objects near the garage door.
The unit has red LED is the transmitting
sensor. The unit has green LED is the
receiving sensor. Avoid sun light shinning
directly into the receiving sensor.
Note: Receiving sensor has
a label marking “Receive”
on the wire.
Follow the same procedure to
install the sensor on the other
track. Ensure they are on the
same level facing each other.
6” max above floor
Loosen the wing nut on
the mounting bracket.
Slide the mounting bracket
onto the garage door track
and tighten the wing nut.
Ensure the sensor is no
higher than 6” (15cm)
above floor. Tighten the
wing nut so the safety
beam sensor is secure on
the door track.
-16-
CONNECT THE OPENER TO POWER
- Be sure power is not connected to the garage door
opener while installing the safety beam sensor.
- The safety beam sensor must be installed and
aligned properly.
- This safety device must not be disabled.
- The safety infrared sensor must not be installed
higher than 6” (15cm) above the garage floor.
6” Max
Rec
eiv
e
LED
Wing Nut
WARNING
WARNING
