CAUTION
To avoid installation difficulties, do not run the garage door
opener until instructed to do so.
1. Align the rail sections
[J1]
on a flat surface as shown and slide the
tapered ends into the larger ones. Pay attention to the 2 unique rail
sections, the “Door End” and “Motor End” sections as shown.
2. Slide the Trolley Assembly
[J3]
from the “Motor End” as shown.
Note the
[
]
icon should point towards “Door End”.
3. Secure 2 clip washers
[C3]
into the “Door End” window as shown,
line up the holes on the clip washers and on the rail.
4. Place the idler pulley
[J2]
into the window as shown.
5. Insert the idler bolt
[C1]
from the top through the rail and pulley,
secure with the hitch pin
[C2]
.
To prevent INJURY from pinching, keep hands and
fingers away from the joints while assembling the rail.
4 Middle
Sections
Motor End
Door End
To Mot
or
To Door
J3
C1
C3
C3
J2
C2
Step 1 – Assemble the rail and insert the trolley
7
ASSEMBLE THE RAIL
