To operate the garage door opener with the remote, press the desired
button on the remote control.
If the remote control does not operate the garage door opener, please
follow instructions Page 23 Programming additional remote / keypad
to program the remote control to the garage door opener.
Passcode Protection (ONLY for 3-Button Remote)
You can enable the passcode protection on the 3-button remote.
Once enabled, passcode must be entered to unlock the remote before
it can operate the garage door opener. The factory default setting is
passcode function disabled.
To enable passcode protection:
1. Press and hold buttons 1 and 3 simultaneously 6 seconds
until the LED flashes.
2. Enter the passcode (default passcode is 2 2 2), i.e. press
button 2 three times.
3. Press and hold buttons 1 and 3 simultaneously, LED flashes once,
passcode function is now enabled.
Remote Control
To change the passcode:
1. Press and hold buttons 1 and 3 simultaneously 10 seconds until the
LED changes from flashing quickly to flashing slowly.
2. Enter the old passcode (default passcode is 2 2 2)
3. Press and hold buttons 1 and 3 simultaneously, if LED flashes once,
enter the new passcode (from 2-8 digits). If LED flashes 3 times, you
have entered the incorrect passcode. Start again from step 1.
4. After entering the new passcode, press and hold buttons 1 and 3
simultaneously to confirm.
Toggle between enable / disable passcode protection
1. Press and hold buttons 1 and 3 simultaneously 6 seconds until the
LED flashes.
2. Enter the passcode (default passcode is 2 2 2), i.e. press button 2
three times.
3. Press and hold buttons 1 and 3 simultaneously, LED flashes once,
passcode function is toggled, i.e. from disable to enable, or enabled
to disabled).
Forgot Passcode and Factory Reset
If you forgot your passcode or would like to change the passcode to
factory default 2 2 2, follow the steps below.
1. Press and hold buttons 1 and 2 for 10 seconds until the LED flashes.
2. Release both buttons. Passcode function is now disabled and
passcode is set to factory default 2 2 2.
27
OPERATION
