SkyLink ATOMS Series, Owner'S Manual

Page: 36 / 38

Opener works from door control,
but not remote control.
SYMPTOM SOLUTION
1. Ensure Remote Lock on the Deluxe / LCD Wall Console is disabled.
2. Reprogram the remote. 3. Replace remote battery.
Door reverses after it’s
completely closed.
1. Check for any obstacles on the ground in the path of the door stopping the door to close completely.
2. Re-program the down travel limit to avoid door closing too far down. Refer to “Programming the
travel limits” to set the travel limit.
Door opener runs very slow.
Check operating condition of the door, ensure the door is balanced properly.
Contact a trained door technician for service if needed.
Door will not close and LED
display showing “b”.
“b” indicates safety beam sensor is blocked while door is closing. Check the following:
1. Ensure the safety beam sensors are installed and wired properly. Refer to “Install the safety beam sensors”.
2. Ensure both red and blue LED on the safety beam sensors are steadily on. Refer to “Aligning the safety
beam sensors” to check the LED status and sensor alignment.
3. If problem exists and door will not close, the opener can be forced to close by pressing and holding the
door control door button until the door is completely closed. CAUTION: Keep garage door in sight
until the door is fully closed, then release the door button.
Door will not close and LED
display shows “F”
1. Check door for binding, lubricate rollers or hinges if needed. Refer to “Regular Maintenance”.
2. Check operating condition of the door, ensure the door is balanced properly. Contact a trained door
technician for service if needed.
3. Check the chain / belt tension. “F” will show up if the chain / belt is overtightened. Loosen up the tension
a bit to the desired tension. Refer to “Tighten the chain / belt” for more information.
When opener is activated, turnbuckle
moves but door does not.
Ensure the trolley is connected to the turnbuckle. Refer to “Manually Open / Close Garage Door” to
connect the trolley properly.
Travel limit changes on
a belt drive opener
Ensure the belt’s tension is not too loose which may cause the belt to slip resulting in changing the
travel limit. Refer to the section “Tighten the chain / belt” to adjust the tension.
35
TROUBLESHOOTING