SkyLink ATOMS ANR Series, Instruction Manual

Page: 11 / 32

1. Attach Emergency Release Rope 3. Connect the Door Arm to the Trolley
4. Connect the Door Arms Together
Bring two arms together. Find two pairs of holes that line up and join 2 arms with bolts and nuts.
Select holes as far apart as possible to increase door arm rigidity.
2. Connect the Door
Arm to Door Bracket
Sectional Door
Connect the curved door arm to the door bracket
with clevis pin and hitch pin.
One-piece Jamb Door
Connect the straight arm to the door bracket
with clevis pin and hitch pin.
One-piece Jamb Door
Connect the curved door arm to the trolley with
clevis pin and hitch pin.
Sectional Door
Connect the straight door arm to the trolley with
clevis pin and hitch pin.
Sectional Door One-piece Jamb Door
NOTE:
• Emergency release handle should hang 6’ (1.8 m) above floor. Adjust rope length if it is
necessary.
WARNING
• Use extreme care when pulling release handle. DO NOT use handle to pull door open or close.
• Never use emergency release handle unless garage doorway is clear of persons and
obstructions.
INSTALL THE DOOR ARMS
INSTALL THE DOOR ARMS INSTALL THE DOOR ARMS
21 21 22 22
B8 X2
B2 X2
B9 (X1)
B6 (X1)
Engaged
Released
E1 (x1)
E1 (x1)
E2 (x1)
E2 (x1)
F2(x1)
F1(x1)
F3 (x2)
F4 (x2)
F3 (x2)
F4 (x2)
Thread the red rope through the hole in
the trolley release handle and tie an
over-hand knot. Leave the trolley release
lever in the released position until further
testing is completed.