•
If the zone LED remains off, that indicates that zone is not occupied by any sensor.
•
If the zone LED flashes once, that indicates sensor 1 of that zone is occupied.
•
If the zone LED flashes twice, that indicates sensor 2 of that zone is occupied.
5.
You may now select which sensor lo
ase
zone and sensor number
by pressing buttons [1
utton
prese
6 to 0 represent sens
ones
r sel
ensor location, you will
hear 3 beeps and “Zone_ Sensor_ E
ory”.
rms the selected sensor
has been erased, and
OG] L
ff. To erase another sensor, repeat the
above steps.
Sensor 1
Sensor 2
cation to er
. Select the
] to [0]. B
s 1 to 5 re
1 to 5. Afte
nt sensor 1 for zones 1 to 5. Buttons
ecting the s
or 2 for z
mpty Mem
This confi
the [PR
ED will be o
Zone 1
Button [1]
Button [6]
Zone 2
Button [2]
Button [7]
Zone 3
Button [3]
Button [8]
Zone 4
Button [4]
Button [9]
Zone 5
Button [5]
Button [0]
e Remotes / Receiver
E
ras
Follow the instructions below to erase keychain or keypad remotes / receivers.
1.
Press the [PROG] button on the side of the control panel, the [PROG] LED will be on.
2.
Enter the current Master Password. Control panel will emit 3 beeps if the valid password
is entered, otherwise a single long beep will be emitted and [PROG] LED will be off.
3.
Enter [0], which represents “Erase Keychain / Receiver”. Notice all 5 zone LEDs, some of
them may be off, some of them may flash once, some of the may flash twice. The LED
flashing represents the occupied sensors.
•
If the zone LED remains off, that indicates that zone is not occupied by any keychain /
receiver.
•
If the zone LED flashes once, that indicates a receiver has occupied that device. Zone 1
LED flashes once means Device 1 is occupied.
•
If the zone LED flashes twice, that indicates a keychain / keypad remote has occupied that
zone. Zone 1 LED flashes twice means Device 6 is occupied.
4.
To erase a receiver, enter a device number from Device 1 to Device 5. To select device 1,
press button 1. Once a device is selected, you will hear 3 beeps and “Device_ Empty
Memory”.
5.
To erase a keychain, enter a device number from Device 6 to Device 0. To select device 6,
press button 6. Once a device is selected, you will hear 3 beeps and “Device_ Empty
Memory”.
6.
To erase another remote / receiver, repeat the above steps.
