feature was disabled for all zones at the factory.
This
To en le
1.
Press
e [PROG] LED will be on.
2.
is en
D will be off.
ab event trigger, follow the instructions below.
the [PROG] button on the side of the control panel, th
Enter the current Master Password. Control panel will emit 3 beeps if the valid password
tered, otherwise a single long beep will be emitted and [PROG] LE
3.
Enter [7], which represents “Event Trigger” setting. Notice all 5 zone LEDs, some of them
may be off, some of them may flash once, some of them may be on steadily. The LED
flashing represents the current event trigger setting.
•
If the zone LED is off, that indicates event trigger is disabled.
•
If the zone LED flashes, that indicates event trigger is enabled, and it will turn off the
corresponding device when the sensor(s) is activated
•
If the zone LED remains steadily on, that indicates event trigger is enabled, and
turn
it will
on the corresponding device when the sensor(s) is activated
.
To change the event trigger setting, press buttons 1 to 5 will d
zones. P ssing buttons 6
event trigger for those zones. However, even
this feature is enabled, you still have to select whether you want to turn that device on or
off when the sensor(s) is trig
ssing buttons [6] to [0] will toggle the setting
between on and off. For exa
LED is currently
vent trigger for zone 2
is enable with the Off signal, you can press button [7] to change it to the On signal.
Pressing [7] again will change it back to Off signal. Refer to Fig X. After making the
change, notice the status of the zone LED changes as w
Disable Event
Trigger
Enable Event Trigger
(Toggle between Off
4
isable event trigger for those
re
to 0 will enable
gered. Pre
mple, if the
showing e
ell.
and On)
Zone 1
Button [1]
Button [6]
Zone 2
Button [2]
Button [7]
Zone 3
Button [3]
Button [8]
Zone 4
Button [4]
Button [9]
Zone 5
Button [5]
Button [0]
5.
You are allowed to make unlimited changes before programming is quit. Once you are
satisfied with the settings, press [PROG] to quit programming and the settings will be
ote: If event triggered is enabled for a door sensor, which turn lights on when it is open, this
ave
n operate in 2 different modes, 1) Alert Mode, 2)
nd immediately (with instant
not want to trigger the alarm when the system
saved.
N
feature will not be activated during exit delay. Since during exit delay, users suppose to le
the premises and therefore lights will not be turned on. However, if the event triggered is
enabled to turn lights off, it will be activated during exit delay.
Zone Dependent Setting – Alert Zone
As explained earlier, the control panel ca
Security Mode. In security mode, when a sensor is triggered, the control panel will need to be
disarmed either after 30 seconds (with entry delay), or siren will sou
alarm). However, there are sensors that you do
