SkyBell 2.0, Installation Manual

Page: 8 / 17

4
ACCESSORIES
Wedge Mount Accessory
The wedge mount allows you
to angle SkyBell in the direction of
your door or visitors.
1.
Remove your old doorbell chime from the wall and either
detach or cut the wires currently connected to your traditional
doorbell.
2.
Place the wedge mount so that the back of the wedge mount
faces the wall. You should see a small ridge around the circle
facing outward. Be sure that the wires are sticking through the
center hole in the wedge mount.
3.
Position the wedge mount so that the camera will be angled in
the direction of your visitor.
4.
Place the wall mount on top of the wedge mount and position
so that the bottom of the wall mount (the end with the set screw)
is at the center of the thinnest part of the wedge mount. Be sure
that the wires pass through the center hole in the wall mount.
5.
Place two screws into the wall mount so they go through the
holes in the wedge mount. Secure the screws to the wall.
Follow the rest of the installation instructions on page 10.
For more support documentation, visit:
http://www.skybell.com/support
13 14