SkyBell 2.0, Installation Manual

Page: 5 / 17

3. WITHOUT A DOOR CHIME
Setup 1:
Primary Power;
Low-voltage transformer (10-36 VAC 10 VA); and
10 Ohm/10 Watt resistor inserted between one wire from the
SkyBell and one wire from the power source
Setup 2:
12 VDC power supply; and
10 Ohm/10 Watt resistor inserted between one wire from the
SkyBell and one wire from the power source
Warning!
Installing your SkyBell with an improper power configuration
will automatically void your Limited Warranty
(http://www.skybell.com/warranty).
Warning!
Coming into contact with a transformer can cause injury or loss
of life. Use extreme caution when installing SkyBell.
OR
3
INSTALLATION INSTRUCTIONS
1.
To begin, press your
current doorbell button
to make sure your existing
door chime works.
2.
Remove your traditional
doorbell and carefully detach
or cut the 2 wires currently
connected to your traditional
doorbell.
3.
Run the wires through
the center of the mounting
plate. Be sure the front side
of the mounting plate
faces you.
7 8