Now the basic setup of CC3D is completed, you need to double check that everything is done correctly.
Go back to OpenPilot homepage and click “Configuration” tab at the bot-
tom and have a look at the “HW Settings”.
If you’ve chosen S.Bus receiver
in the wizard:
Click “Hardware” tab on left, check the Flexi Port and Main Port settings
and make sure they are the same as on the screenshot. If there’s any diffe-
rence please change accordingly and click “Save”.
Now it’s time to calibrate the radio, click “Input” tab on the left and click on “Start Transmitter Setup Wizard”.
Accept the safety notice by click “OK”
Click “Next”
APPENDIX 3: SETUP ANAKIN SETTINGS IN FLIGHT CONTROLLER
Select “Acro” then click “Next”.
Select the correct mode according to your transmitter and click “Next”,
carefully follow the screen prompt until the calibration process is finished.
Make sure you fully understand the arming process and select the pre-
ferred arming combination under
“Arming Settings”
. Don’t forget to click
“Save” to save all the settings.