37
SKOPE TME-N ActiveCore
Replacement Procedures
Service Manual
Hinge
Reversal
The single door cabinet is supplied with the door hinged on the RH side. If
required, the hinge can be swapped to the LH side. Some spare parts are
required to complete the procedure, and are available in the LH Hinge Kit.
To reverse the door hinging
1. Remove the door from the cabinet (see page 34).
2. Remove the door lock bracket from the top of the cabinet.
3. Remove the bottom hinge, tension bracket and height adjustment block. Retain
the tension bracket and height adjustment block (these are fitted to the
opposite side once the door is refitted). The bottom hinge can be discarded.
4. Unplug the door switch cable from the cabinet. The door switch is fitted to the
door switch bracket, above the door.
5. Fit the new bottom hinge.
6. Remove the door lock bracket from the door, and fit to the opposite end.
7. Remove the bush and retain
for the other end of the door.
8. Remove the capstan, bush
and bush washer, and
unhook from the torsion bar.
Note:
The torsion bar
cannot easily be removed
from the door. Push the
torsion bar into the door
frame.
Fit the capstan, bush and
bush washer to the new
torsion bar, and fit this
assembly to the opposite
end of the door.
9. Fit the bush (retained from
step 7) to the end of the
door, opposite the capstan.
10. Remove the door switch
magnet from the end of the
door, and fit to the opposite
end.
Note:
Ensure the magnet is
orientated correctly and
does not protrude past the
frame edge.
11. Refit the door (see page 34).
12. Apply the SKOPE logo label
to the top LH corner of the
door. Use the label backing
to align the label as
pictured.
13. Apply the blanking labels
over the upside down logos
at the bottom of the door.
Torsion bar
Bush
washer
Capstan
Bush
Door lock bracket
Door switch magnet
