5
SKOPE OD460
Installation
User Manual
Positioning the Cabinet
Climate Class
The OD460 chiller is designed to operate within a climate class 3
environment (25°C @ 60% RH). We recommend that you put the chiller in
the coolest place possible because it will use less power and last longer.
Chiller
Location
The location of the chiller may be the single most important decision that will
extend its life and ensure economical, high performance. Ensure the cabinet
is placed where it is not exposed to drafts or direct sunlight. The cabinet
must sit on a level surface to prevent the condensate tray from overflowing.
Air Movement
The cabinet must
NOT
be situated where it is affected by air-conditioning air
outlets, ventilation fans or air re-circulation fans, as this will compromise the
airflow and thus product temperature in the open cabinet zone.
There must be
NO
air movement directly into the cabinet opening. Air
movement will cause failure of the air curtain over the product, resulting in
excessive temperature rise. Detectable air draft will adversely effect the
cabinet operation. Maximum air movement across the cabinet opening must
not exceed 0.2 m/s.
Power Cord
The cabinet has a flexible power cord fitted with a 3-pin plug, which exits the
rear of the cabinet at floor level. Locate the power cord before the cabinet is
moved into position so that it is not trapped behind the cabinet.
The cabinet must have its own dedicated power supply. Multi-plug
connecting boxes and extension cords must not be used. Check the cabinet
does not overload the power supply (see the rating label inside the cabinet
for current draw).
Ventilation
Adequate ventilation must be provided around the refrigeration unit and
cabinet at all times. Refrigeration exhaust air must not be restricted, and
must be able to easily flow out and away from the cabinet.
Ensure there is unimpeded clearance in front of the kick panel at all times.
Never store cardboard cartons or other items in the front or rear of the
refrigeration unit.
Determine if the installation is free-standing or enclosed, and ensure the
installation meets the ventilation requirements detailed below.
Free-standing installations
Free-standing cabinets must be installed with the following minumum
clearances:
30mm behind (provided by the rear spacers on the back of the cabinet).
60mm on either side of the cabinet.
200mm above the cabinet.
If these clearances can’t be met, the installation should be treated as an
enclosed installation.
IMPORTANT
There must be
NO
air movement directly into the cabinet
opening.
CAUTION
Ensure adequate ventilation clearance around the refrigeration
unit and cabinet.
