General comments
15
Note
If the navigation CD is inserted there is the possibility beforehand to delete the
stored destinations. If you wish to delete the stored destinations, select the menu
point “
YES
”, if not, select “
NO
”.
Anti-theft protection
Anti-theft coding
The anti-theft coding of your navigation system prevents an operation of the
system after a voltage interruption, e.g. during a vehicle repair or after theft.
After disconnecting the battery, after separating the navigation system from the on-
board voltage of the vehicle and after a defective protection, the entry of the code
is required when operating.
In such cases “
SAFE
” is shown in the display after switching on.
Caution
•
This code number is affixed together with the unit number on the “Unit card”,
which is located
behind
the instructions.
•
The “unit card” must be disconnected and stored
outside
the vehicle.
Note
The code is normally stored in the instrument cluster. Through this the navigation
system is automatically decoded (convenience coding). A manual entry of the code
is normally not necessary.
Code entry
The electronical lock is cancelled by entering the correct code. The order
of the following operating steps must be maintained:
– Switch on the navigation system - after the start screen with the
display “
SAFE
” the request for entry of the code number is displayed
after 2 seconds “
1000
” is shown on the display.
– Continue pressing the station selection button
1
until the first digit
of the code number is shown in the display.
– Insert the other digits of the code number by repetitively pressing the
station selection button
2
, and/or
3
or
4
.
– If the entire code number was entered, press the menu knob
or the
button
or the button
for at least 2 seconds.
Entry of an incorrect code number
If inadvertently an incorrect code number was confirmed when entering, “
SAFE
” is
shown again in the display. First of all flashing and then permanent. “
WRONG
TRIES: 1
” is shown on the display.
Now the entire process can be repeated once again.
If the code number is entered incorrectly for the second time, the navigation system
will be blocked for approx. one hour. It is only possible to repeat the entry of the
code number after an hour has expired and while the navigation system is switched
on and the ignition key remains in the ignition lock.
If once again two non-valid attempts are undertaken, the navigation system will be
blocked again for an hour.
The cycle - two attempts, blocked for an hour - furthermore applies.
Note
Please do not hesitate to contact your Škoda Service Partner should you have lost
the “unit card”.
A
22
A
22
A
25
A
1
A
14
s2ck.7.book Page 15 Friday, April 20, 2007 12:38 PM
